■ Termination Mode (B-Linx Termination Mode, ECP/EUP/ETP products)

• Provides information about the cables used where the camera will be installed.
• Shows the power consumption (Watt) available for the measured cable (Review of the PoE cameras that can be installed is possible).
• Cable resistance (Ohm) from the receiver (Rx) to the tester.
• Voltage supplied from the receiver (Rx) to the tester (The tester measures overvoltage and undervoltage, not the supply voltage).
• Shows an Error when an operation failure is likely to happen on a PoE product (based on the cable voltage drop).
• Shows the measurement information (periodic measure, shown on the Display window).
• The tester does not work if it is not connected to a receiver (Rx). The tester does not have a battery, and operates with the output voltage of the receiver (Rx).

■ Bypass Mode (cable connection mode, PoE)

• The tester is set in the middle of the PoE cable and measures the cable performance while the camera is in operation.
• Measures the power consumption (Watt) while the camera is in operation.
• Measures the cable voltage (Volt) while the camera is in operation.
• Measures the power consumption of the camera when the tester is installed on the camera side.
• Shows real-time measurements (periodic measure, shown on the Display window).
• Operates when a PoE camera (PD device) is connected to the PoE Output terminal.
• The tester might not work if it is not used with a PD device. (The tester does not have a battery, and operates with the output voltage from the PSE).​