■ Termination Mode (B-Linx Termination Mode, ECP/EUP/ETP products)
- Provides information about the cables used where the camera will be installed.
- Shows the power consumption (Watt) available for the measured cable (Review of the PoE cameras that can be installed is possible).
- Cable resistance (Ohm) from the receiver (Rx) to the tester.
- Voltage supplied from the receiver (Rx) to the tester (The tester measures overvoltage and undervoltage, not the supply voltage).
- Shows an Error when an operation failure is likely to happen on a PoE product (based on the cable voltage drop).
- Shows the measurement information (periodic measure, shown on the Display window).
- The tester does not work if it is not connected to a receiver (Rx). The tester does not have a battery, and operates with the output voltage of the receiver (Rx).
■ Bypass Mode (cable connection mode, PoE)
- The tester is set in the middle of the PoE cable and measures the cable performance while the camera is in operation.
- Measures the power consumption (Watt) while the camera is in operation.
- Measures the cable voltage (Volt) while the camera is in operation.
- Measures the power consumption of the camera when the tester is installed on the camera side.
- Shows real-time measurements (periodic measure, shown on the Display window).
- Operates when a PoE camera (PD device) is connected to the PoE Output terminal.
- The tester might not work if it is not used with a PD device. (The tester does not have a battery, and operates with the output voltage from the PSE).
Category |
Language |
Size |
Filename |
File |
Manual |
English |
En |
277.14 KB |
QM_ITS-100_Eng_Rev.2.0_231226.pdf |
|
Manual |
Korea |
kor |
302.39 KB |
QM_ITS-100_Kor_Rev.2.0_231226.pdf |
|
Specsheet |
English |
En |
1.03 MB |
SP_ITS-100_Eng_Rev4.0_231228.pdf |
|
Specsheet |
Korea |
kor |
1.08 MB |
SP_ITS-100_Kor_Rev4.0_231228.pdf |
|
Specsheet |
Japanese |
Jpn |
454.19 KB |
SP_ITS-100_Jpn_Rev2.0_210322.pdf |
|